Determination of long-term radiation ageing in polymers - Effects of different temperatures and dose rates under radiation condition1 Scope This part of IEC 61244 provides general guidance for the evaluation verification of electrical insulation materials (EIM) and electrical insulation systems (EIS) intended to be used in types of equipment exposed to ionizing radiation. Beside sensors, actuators motors as well as plugs and terminals, cables are a well known typical application of those EIM and EIS. Their type spectrum covers low voltage power cables, control cables and

Manufacturers and formulators of thermoset cold curing resin formulations

the test method and the state of anisotropy

This part of ISO 14531 may also be used in conjunction with the restricted specification for PE heat-fusion fittings detailed in ISO 14531-2 to support the introduction of a hybrid PE-X pipe/PE fitting system for operation within a narrower temperature range (− 20 °C to + 40 °C) with a maximum pressure as determined by ISO 8085-3

along with test methods

Aluminium is lighter than steel

— additional requirements specific to the implementation of UDS on the FlexRay network

NOTE 1 Because sling chains are solution-annealed in the finished condition

Details of a suitable head flushness gauge for countersunk head screws and a gauge for checking recess penetration on recessed head screws together with testing requirements for the inspection of tapping screws and approximate hole sizes for steel screws in various materials

— concrete implementation specifications for implementation of security for an EFC system

NOTE: PAS 14191 covers the development

Who is BS EN 10136 - Determination of nickel content for

For anyone whose life is at risk from respiratory failure